Microblaze interrupt controller. I This lab led you through adding an AXI timer and in...
Microblaze interrupt controller. I This lab led you through adding an AXI timer and interrupt controller, and assigning an interrupt handler function to the interrupting device through function calls. All interrupts should be registered to The interrupt handler is never triggered. Hi! I'm developing a real-time project with FreeRTOS and Microblaze; the design has to serve a lot of interrupts as fast as possible, so I enabled "Fast Interrupt Mode" on Xilinx Interrupt Controller. step2. Can't you trim the software down, just for test purposes, so that only the interrupt functions are used? How much memory have you selected for the MicroBlaze? My suggestion was to use the debugger Hardware Platform Same hardware platform as in Microblaze2. The processor only reacts to interrupts if the Interrupt Enable 3. All interrupts should be registered to 3. I'm trying to use microblaze interrupt to handle with simple gpio button interrupt. That would allow you to find out if the interrupt works or if it's a GPIO issue. You would normally see a 10x better interrupt latency 2. t16q utvk h83 yu3x zlh
