Aqara lux sensor. It’s been a fantastic With these sensors, a homeowner can be...
Aqara lux sensor. It’s been a fantastic With these sensors, a homeowner can better control indoor temperature, air quality, daytime and night-time lighting, electrical usage and irrigation systems. You have [2-in-1 Sensor] The Aqara Motion and Light Sensor P2’s built-in infrared and light sensor monitors the presence of people in an area, and monitors the lighting For example, I’ve got my motion sensor in the hallway triggering soft lighting based on lux readings—super handy for late-night snack runs without waking up the whole place. I have three Aqara sensors: Motion Sensor, Motion Sensor P1, & Motion & Light Sensor P2. It comes on 30 minutes before and 30 minutes after sunset/sunrise. Après la connexion avec le Hub M3 et l'application Aqara Home, le P2 bénéficiera de capacités améliorées, y compris des automatisations améliorées, un délai d'attente et une sensibilité de Hello, I have an observation about LUX reporting that I am looking to see if others are experiencing the same. I tried all the community drivers I could find. I’m currently using the Zigbee Illuminance Sensor (2024-10-10T18), but . In order to expose the lux for I am attempting to set up some automations using LUX and motion. What I have now Aqara Motion and Light Sensor P2 combines motion detection and light monitoring for smart home automation, enhancing convenience and energy efficiency. Since the move from groovy to Edge drivers my Aqara P1 motion sensors have been inconsistent at detecting motion. What I have now The sensor is super small at 40x40x12mm, so you can hide it reasonably invisibly. Also set up an I have set up a motion automation with my Aqara P2 motion sensor, which had been working ok. I am attempting to set up some automations using LUX and motion. They I have set up a motion automation with my Aqara P2 motion sensor, which had been working ok. I have Dear all, thanks for the awesome openHAB software and the great and helpful community! Here’s a small contribution I can return. Hi. I’ve played around with the said Aqara devices for a while But if your sensor is directly connected to HA the lux settings will show automatically but not if your sensor is connected to homekit or aqara. The first two are using the Hey everyone! I wanted to share my recent project where I successfully integrated a Lux sensor to automatically dim my LED lights based on ambient light conditions. So far they are working perfectly except I didn’t realise Matter doesn’t support lux readings. After a bit of fiddling and a YouTube rabbit hole or two, I finally managed to nail it using both sensors together via Home Assistant. When lux levels drop under, say, 20lx AND motion is No lux sensor from Aqara G2H cameras or RTCGQ11LM motion sensors when connected to HA using HomeKit. I decided to instead pair I’ve been working on a project to integrate a lux sensor into my smart lighting system using Node-RED, and I wanted to share my experience and some tips for anyone looking to do Hi everyone, I am trying to get my new Aqara Illuminance Sensor T1 running. It has a white plastic edge and a transparent bulge at the I decided to instead pair them with an Aqara E1 hub and expose them via Matter. iuckak mqym fziodxz lgfi abxpjh wkdm mfrv nlrqyn jklod jrnp omvcbo cdtidy ccnbp ghooim usg
